Honeywell ATC928G3000 - Wireless Cylinder Thermostat (CS92)

31
evohome Controller (ATC928G2000)
Wireless Cylinder
Thermostat (CS92)
To bind a Wireless Cylinder Thermostat (CS92) to an evohome
Controller (ATC928G2000) to control a hot water cylinder...
On the evohome Controller
1
Press and hold SETTINGS for 5 seconds
2
Press the green tick
3
Press SYSTEM DEVICES
4
Press the button next to “Sundial Valves:”
5
Press STORED HOT WATER
6
Press HOT WATER SENSOR BINDING
On the Wireless Cylinder Thermostat
7
Press and hold the button for 5
seconds. The green light should come
on and the red light should flash
8
Press the button again
You should receive a SUCCESS message on
the evohome Controller and the LED on the
Wireless Cylinder Thermostat should stop blinking
and turn OFF. If not go back and re-bind.
evohome Controller
(ATC928G2000)