10
Wireless connectivity Guide
To bind a Room Temperature Sensor (HCF82) to a Wi-Fi evohome Controller
(ATC928G3000) as the room temperature sensor in a zone...
On the evohome Controller
1
Press and hold SETTINGS for 5 seconds
2
Press the green tick
3
Press ZONE CONFIGURATION
4
Press on the required zone
5
Press TEMPERATURE SENSOR
6
Press REMOTE SENSOR
7
Press the green tick
On the Room Temperature Sensor
8
Press the bind button on the bottom
right hand corner of the unit once
– the red LED light will flash
You should receive a SUCCESS message on the
evohome Controller. If not go back and re-bind.
Room Temperature
Sensor (HCF82)
Wi-Fi evohome Controller
(ATC928G3000)
To Next Page
Loading...
Need help?
General
