Honeywell ATC928G3000 - Remote Access Gateway (RFG100)

26
Wireless connectivity Guide
To bind a Remote Access Gateway (RFG100) to an evohome Controller (ATC928G2000)...
On the evohome Controller
1
Press and hold SETTINGS for 5 seconds
2
Press the green tick
3
Press SYSTEM DEVICES
4
Press the button next to “Remote Gateway:”
5
Press REMOTE GATEWAY
On the Remote Access Gateway
6
Press and hold the bind button on the base until
you see a flashing green light next to the icon
On the evohome Controller
7
Press the bind button
You should receive a SUCCESS message
on the evohome Controller and the LED on
the Remote Access Gateway should turn
solid green. If not go back and re-bind.
Register the Remote Access Gateway
8
Go to mytotalconnectcomfort.com to
register the Remote Access Gateway.
Remote Access
Gateway (RFG100)
evohome Controller
(ATC928G2000)