42
Wireless connectivity Guide
To bind a Remote Access Gateway (RFG100) to a Single Zone Thermostat (T87RF)...
On the Remote Access Gateway
1
Press and hold the bind button on
the base until you see a flashing
green light next to the icon
On the Single Zone Thermostat
2
Press and hold on the right touch
zone (just below and to the right of the
display) for approximately 10 seconds
until a flashing ‘Bnd’ is displayed
3
Press the right touch zone once to send the
binding signal to the Remote Access Gateway
The Single Zone Thermostat will briefly
show the signal strength and the LED on
the Remote Access Gateway should turn
solid green. If not go back and re-bind.
Remote Access
Gateway (RFG100)
Single Zone Thermostat
(T87RF)
To Next Page
Loading...
Need help?
General
