Honeywell ATC928G3000 - Wireless Relay Box (HC60 NG)

18
Wireless connectivity Guide
To bind a Wireless Relay Box (HC60NG) to a Wi-Fi evohome
Controller (ATC928G3000) to control a boiler...
On the evohome Controller
1
Press and hold SETTINGS for 5 seconds
2
Press the green tick
3
Press SYSTEM DEVICES
4
Press BOILER CONTROL
5
Press WIRELESS RELAY BOX
On the Wireless Relay Box
6
Press and hold the button for 15 seconds
(until the red LED blinks rapidly) to
clear any previous binding data
7
Press and hold the button again for 5
seconds (until the red LED blinks slowly)
On the evohome Controller
8
Press the bind button
You should receive a SUCCESS message
on the evohome Controller and the LED on
the Wireless Relay Box should stop blinking
and turn OFF. If not, go back and re-bind.
Wireless Relay Box
(HC60NG)
Wi-Fi evohome Controller
(ATC928G3000)