Honeywell ATC928G3000 - Radiator Controller (HR92)

24
Wireless connectivity Guide
To bind a Radiator Controller (HR92) to an evohome
Controller (ATC928G2000) “radiator valve” zone...
On the evohome Controller
1
Press and hold SETTINGS for 5 seconds
2
Press the green tick
3
Press ZONE SETTINGS
4
Press EDIT ZONE
5
Press on the required zone
6
Press the button next to “Application:”
7
Press RADIATOR VALVE
On the Radiator Controller
8
Press the button once − it
should display UNBOUND
9
Press and hold the button for a further
5 seconds until it displays BIND
10
Press the button once – it
should display BINDING
On the evohome Controller
11
Press the bind button
You should receive a SUCCESS message on
both the evohome Controller and the Radiator
Controller. If not go back and re-bind.
Radiator Controller
(HR92)
evohome Controller
(ATC928G2000)