28
Wireless connectivity Guide
To bind a Room Temperature Sensor (HCW82) to an evohome Controller
(ATC928G2000) as the room temperature sensor in a zone...
On the evohome Controller
1
Press and hold SETTINGS for 5 seconds
2
Press the green tick
3
Press ZONE SETTINGS
4
Press EDIT ZONE
5
Press on the required zone
6
Press the button next to “Sensor:”
7
Press REMOTE RF DEVICE’S SENSOR
On the Room Temperature Sensor
8
Press the bind button on the bottom
right hand corner of the unit once – the
red LED light will flash once to indicate
the binding signal has been sent.
You should receive a SUCCESS message on the
evohome Controller. If not go back and re-bind.
Room Temperature
Sensor (HCW82)
evohome Controller
(ATC928G2000)
To Next Page
Loading...
Need help?
General
