Honeywell ATC928G3000 - Wireless Opentherm Bridge (R8810)

19
Wi-Fi evohome Controller (ATC928G3000)
To bind a OpenTherm Bridge (R8810) to a Wi-Fi evohome Controller
(ATC928G3000) to control an OpenTherm™ boiler...
On the evohome Controller
1
Press and hold SETTINGS for 5 seconds
2
Press the green tick
3
Press SYSTEM DEVICES
4
Press BOILER CONTROL
5
Press OPENTHERM BRIDGE
On the OpenTherm Bridge
6
Press and hold the button for 15 seconds
(until the red LED blinks rapidly) to
clear any previous binding data
7
Press and hold the button again for 5
seconds (until the red LED blinks slowly)
On the evohome Controller
8
Press the bind button
You should receive a SUCCESS message on
the evohome Controller and the LED on the
Wireless OpenTherm Bridge should stop blinking
and turn OFF. If not, go back and re-bind.
Wireless OpenTherm
Bridge (R8810)
Wi-Fi evohome Controller
(ATC928G3000)