Honeywell ATC928G3000 - Room Temperature Sensor (HCW82)

11
Wi-Fi evohome Controller (ATC928G3000)
To bind a Room Temperature Sensor (HCW82) to a Wi-Fi evohome Controller
(ATC928G3000) as the room temperature sensor in a zone...
On the evohome Controller
1
Press and hold SETTINGS for 5 seconds
2
Press the green tick
3
Press ZONE CONFIGURATION
4
Press on the required zone
5
Press TEMPERATURE SENSOR
6
Press REMOTE SENSOR
7
Press the green tick
On the Room Temperature Sensor
8
Press the bind button on the bottom
right hand corner of the unit once
– the red LED light will flash
You should receive a SUCCESS message on the
evohome Controller. If not go back and re-bind.
Room Temperature
Sensor (HCW82)
Wi-Fi evohome Controller
(ATC928G3000)