Honeywell ATC928G3000 - Wireless Opentherm Bridge (R8810); Press and Hold the Button for 15 Seconds (until the Red LED Blinks Rapidly) to Clear any Previous Binding Data Press and Hold the Button Again for; Seconds (until the Red LED Blinks Slowly)

52
Wireless connectivity Guide
Programmable Thermostat
(CM700RF)
To bind a Wireless OpenTherm Bridge (R8810) to a Programmable
Thermostat (CM700RF) to control an OpenTherm™ boiler...
On the Wireless OpenTherm Bridge
1
Press and hold the button for 15 seconds
(until the red LED blinks rapidly) to
clear any previous binding data
2
Press and hold the button again for 5
seconds (until the red LED blinks slowly)
On the Programmable Thermostat
3
Press the OFF button
4
Press and hold the , and
buttons together for approximately 3
seconds until ‘InSt’ is displayed
5
Press to send the binding signal to
the Wireless OpenTherm Bridge
The LED on the Wireless OpenTherm
Bridge should stop blinking and turn
OFF. If not go back and re-bind.
Wireless OpenTherm
Bridge (R8810)