Honeywell ATC928G3000 - Wireless Relay Box (BDR91) Zone Valve

17
Wi-Fi evohome Controller (ATC928G3000)
Wireless Relay Box
(BDR91) Zone Valve
To bind a Wireless Relay Box (BDR91) to a Wi-Fi evohome
Controller (ATC928G3000) Zone Valve zone...
On the evohome Controller
1
Press and hold SETTINGS for 5 seconds
2
Press the green tick
3
Press ZONE CONFIGURATION
4
Press on the required zone
5
Press HEATING TYPE
6
Press ZONE VALVE
7
Press the green tick
On the Wireless Relay Box
8
Press and hold the button for 15 seconds
(until the red LED blinks rapidly) to
clear any previous binding data
9
Press and hold the button again for 5
seconds (until the red LED blinks slowly)
On the evohome Controller
10
Press the bind button
You should receive a SUCCESS message
on the evohome Controller and the LED on
the Wireless Relay Box should stop blinking
and turn OFF. If not, go back and re-bind.
Wi-Fi evohome Controller
(ATC928G3000)