57
Central Heating Timer (ST9000RF)
Programmer or Timer
(ST9000RF)
To bind a Wireless Relay Box (BDR91) to a Programmer or
Timer (ST9000RF) to control a sundial valve*...
On the Programmer or Timer
1
Move the setting slider to RUN
1
Press and hold , and (right hand
side) MODE together for 8 seconds – it
should briefly show “BIND MENU”
2
Press until (Heating valve) or
(Hot Water valve) and CONTROL
are flashing on the display
3
Press and hold for 8 seconds to
clear any previous bind data – it should
show “RESET” for a few seconds
4
Press once
On the Wireless Relay Box
5
Press and hold the button for 15 seconds
(until the red LED blinks rapidly) to
clear any previous binding data
6
Press and hold the button again for 5
seconds (until the red LED blinks slowly)
You should receive a COMPLETE message
on the Programmer or Timer and the LED on
the Wireless Relay Box should stop blinking
and turn OFF. If not go back and re-bind.
Wireless Relay Box
(BDR91)
*only available on specific models and/or system configurations
To Next Page
Loading...
Need help?
General
