Voyager XP User Guide 153
QR Code Message Length
Scan the barcodes below to change the message length. Refer to Message Length
Description (page 114) for additional information. Minimum and Maximum
lengths = 1-7089. Minimum Default = 1, Maximum Default = 7089.
QR Code Append
This function allows the scanner to append the data from several QR Code bar-
codes together before transmitting them to the host computer. When the scanner
encounters an QR Code barcode with the append trigger character(s), it buffers the
number of QR Code barcodes determined by information encoded in those bar-
codes. Once the proper number of codes is reached, the data is output in the order
specified in the barcodes. There are 3 ways to scan appended QR Code:
• One scan—Pull the trigger one time and all appended QR Codes in the same
image are decoded
• Swipe—Pull and hold down the trigger and scan all appended QR Codes while
keeping the trigger pressed. The scanner emits short beeps for each partial QR
Code that is scanned and buffered. One long beep is emitted after the last QR
Code is scanned and the data is complete. Not compatible with Presentation
mode.
• Point and shoot—Pull the trigger one time for each image. The scanner emits a
short beep for each partial QR Code that is scanned and buffered. One long beep
is emitted after the last QR Code is scanned and the data is complete. Not
compatible with Presentation mode.
Default = One Scan.
Minimum Message Length
Maximum Message Length
* One Scan
Swipe
Point and Shoot
To Next Page
Loading...
