Voyager XP User Guide 77
sync with one another. To change the number of beeps, scan the barcode below
and then scan a digit (1-9) barcode and the Save barcode on the Programming
Chart. Default = 1.
Number of Beeps – Error
The number of beeps and LED flashes emitted by the scanner for a bad read or
error can be programmed from 1 - 9. For example, if you program this option to
have five error beeps, there will be five error beeps and five LED flashes in response
to an error. To change the number of error beeps, scan the barcode below and then
scan a digit (1-9) barcode and the Save barcode on the Programming Chart.
Default = 1.
Good Read Delay
This sets the minimum amount of time before the scanner can read another bar-
code. Default = 0 ms (No Delay).
Number of Good Read Beeps/LED Flashes
Number of Error Beeps/LED Flashes
* No Delay
Short Delay (500 ms)
Medium Delay (1,000 ms)
Long Delay (1,500 ms)
To Next Page
Loading...
Need help?
General