2 Voyager XP User Guide
Connect the Device
Connect with USB
A scanner or a cordless base can be connected to the USB port of a computer.
1. Connect the appropriate interface cable to the device first, then to the com-
puter.
Note: The power supply must be ordered separately, if needed.
2. If you connect a CCB01-010BT-V1N Base, make sure the cables are secured in
the wireways in the bottom of the cordless base and the base sits flat on a
horizontal surface.
3. The scanner beeps.
4. Verify the scanner or cordless base operation by scanning a barcode from the
Sample Symbols in the back of this manual.
Corded Voyager XP 1470g
USB Connection:
CCB01-010BT-V1N
Base USB
Connection:
To Next Page
Loading...
Need help?
General