EasyManuals Logo

Honeywell CCB01-010BT-V1N User Manual

Honeywell CCB01-010BT-V1N
246 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #68 background imageLoading...
Page #68 background image
52 Voyager XP User Guide
Scanner Power Time-Out Timer
Note: Scanner Power Time-out Timer only applies to cordless systems. It does not apply to
corded scanners.
When there is no activity within a specified time period, the scanner enters low
power mode. Scan the appropriate scanner power time-out barcode to change the
time-out duration (in seconds).
Note: Scanning zero (0) is the equivalent of setting no time-out.
If there are no trigger pulls during the timer interval, the scanner goes into power
down mode. Whenever the trigger is enabled, the timer is reset. If the scanner is
placed in the charge base cradle and the battery is in the process of being charged,
the scanner will not go into power down mode. Default = 3600 seconds.
Note: When the scanner is in power down mode, pull the trigger to power the unit back up.
There will be a set of power up beeps and a delay of up to a few seconds for the radio
to join. The scanner will then be ready to use.
Scanner Alarm Type
0 seconds
200 seconds
400 seconds
900 seconds
* 3600 seconds
7200 seconds

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell CCB01-010BT-V1N and is the answer not in the manual?

Honeywell CCB01-010BT-V1N Specifications

General IconGeneral
BrandHoneywell
ModelCCB01-010BT-V1N
CategoryScanner
LanguageEnglish

Related product manuals