68 Voyager XP User Guide
Maximum Link Attempts
The Maximum Link Attempts setting controls the number of times the scanner
tries to form a connection with a base or an Access Point. During the connection
setup process, the scanner transmits in order to search for and connect to a base
or an Access Point. In order to prevent continuous transmissions that could inter-
fere with other users of the ISM band, the number of attempts to connect is limited
by this setting. After the maximum number of attempts is reached, the scanner will
not attempt to reconnect to a base or an Access Point. Pressing the trigger, scan-
ning an Access Point linking barcode, or placing the scanner in the cradle resets
the attempt count and the scanner will again try to link.
Scan the Maximum Link Attempts barcode, then scan the number of attempts for
the setting (from 0-100) from the Programming Chart. Scan Save to save the set-
ting. Default = 0.
Note: When Auto Reconnect Mode is On, setting Maximum Link Attempts to zero will cause
the scanner to try to link until the Scanner Power Time-Out Timer setting expires.
When Auto Reconnect Mode is Off, setting Maximum Link Attempts to zero will cause
the scanner to only attempt linking one time after a trigger pull.
Base or Access point reset
(firmware upgrade or power cycle)
Scanner behaves as if out of range. No attempt to relink made while base
or Access Point is powered off. Trigger
must be pulled to initiate relinking.
Scanner power down due to
Scanner Power Time-Out Timer
setting.
Trigger must be pulled, Access Point linking barcode must be scanned, or the
scanner must be placed in the base unit to relink.
(Note: scanner relinks on power up, but powers on due to one of the above actions.)
Scanner reset due to firmware
upgrade
Relink occurs automatically.
Scanner reset due to battery
change
Relink occurs automatically.
Scanner placed in different base
unit
Relink to new base occurs automatically.
Event Auto Reconnect On Auto Reconnect Off
Maximum Link Attempts
To Next Page
Loading...
