Voyager XP User Guide 45
Reset Scanner
Scanning this barcode reboots the scanner and causes it to relink with the base or
Access Point.
Scan While in Base Cradle
If you want to be able to scan barcodes while the scanner is in the base cradle, scan
the Scanning in Cradle On barcode below. If you want to only allow scanning when
the scanner is out of the base cradle, scan Scanning in Cradle Off. If you want the
scanner to shut down when in the base cradle, scan Shut Down Scanner in Cradle.
Default = Scanning in Cradle On.
Base Charging Modes
When the base has both an external power supply (plugged into the auxiliary power
port) and a host interface cable, it will draw its power from the external power sup-
ply. When the base does not have an external power supply, it draws its power from
the interface cable. However, the scanner battery charges more slowly from a host
interface cable than if auxiliary power were available. Using the following selec-
tions, you can specify whether the scanner battery is charged from power supplied
via the host interface cable.
When Base Charge Off is selected, the scanner battery does not charge when the
scanner is in the base cradle.
When External or Interface Cable Power is selected, the scanner battery charges
from the base’s external power supply, if there is one. If there is no external power
supply to the base, the scanner battery charges from the interface cable.
Reset Scanner
Scanning in Cradle Off
* Scanning in Cradle On
Shut Down Scanner in Cradle
To Next Page
Loading...
