Voyager XP User Guide 53
Flexible Power Management
If you are experiencing network performance issues, and suspect the scanner is
interfering with other devices, you can turn down the power output of the scanner.
This reduces the range between the scanner and a base or an Access Point as
shown in the following illustration:
Scan one of the barcodes below to set the scanner’s power output to Full Power
(100%), Medium Power (35%), Medium Low Power (5%), or Low Power (1%).
Default = Full Power.
Batch Mode
Note: Batch Mode is only supported by the Honeywell Charge and Communication Base
(CCB) and Honeywell Access Point (AP).
F
u
l
l
P
o
w
e
r
R
e
d
u
c
e
d
P
o
w
e
r
Scanner
802.11
LAN
* Full Power
Medium Power
Medium Low Power
Low Power
To Next Page
Loading...
Need help?
General