Voyager XP User Guide 9
Reset the Custom Defaults
If you want the custom default settings restored to your scanner, scan the Activate
Custom Defaults barcode below. This is the recommended default barcode for
most users. It resets the scanner to the custom default settings. If there are no cus-
tom defaults, it will reset the scanner to the factory default settings. Any settings
that have not been specified through the custom defaults will be defaulted to the
factory default settings.
Note: If using a cordless system, scanning this barcode also causes both the scanner and
the base or Access Point to perform a reset and become unlinked. The scanner must
be placed in its base to re-establish the link. If using an Access Point, the linking
barcode must be scanned. See Cordless System Operation beginning on page 37 for
additional information.
Activate Custom Defaults
To Next Page
Loading...
Need help?
General