35
Honeywell 30 Series IP Cameras User Guide
Gamma curve: Adjust the image sharpness level (0.45 to 1, Detailed to Contrast).
• Optimize: The system automatically adjusts the gamma curve.
• Manual: Drag the slider to change the preferred level of gamma correction towards
higher contrast or towards the higher luminance for detailed expression for both
dark and lighted areas of an image.
Note:
The gamma curve function is disabled when the WDR feature in Exposure
settings is enabled.
•
The brightness setting from 0% to 100% doesn't have obvious change due to
the limitation of Sony senor.
Defog
Check to improve the visibility quality of captured image in poor weather conditions
such as smog, fog, or smoke.
3D Noise Reduction
Drag the slider to adjust the reduction strength (from low to high).
Note:
3D Noise Reduction is mostly applied in low-light conditions. In a low-light
condition with fast moving objects, trails of after-images may occur. You can
select a lower strength level.
All changes made to image settings are directly shown on screen. To recall the original
settings without incorporating the changes, click RESTORE. After you completed the
settings, click SAVE.
Configuring Exposure Settings
Go to Setup Camera Setup Exposure.
On this page, you can set the Exposure measurement window, Exposure level, Exposure
mode, Exposure time, Gain control, and Day/Night mode settings.
Two sets of exposure settings are available:
• In NORMAL LIGHT MODE tab, configure normal situations for image settings.
• In PROFILE MODE tab, configure special situations for exposure settings.
To Next Page
Loading...
