108 MPA2C3 Installation Guide
You will need to install a USB driver to support the connection. Follow these steps:
Warning: Do NOT connect the USB cable to the panel until AFTER the drivers are installed
1. Download the MPA2C3 USB driver from the link given in below table or scan the
specific QR code to access. https://mywebtech.honeywell.com/Systems/Home
https://honeywelldiscovertraining.com/login/discover/default.asp
2. Click Install USB Drivers on the product menu to start the USB driver installation
wizard.
Figure 3-39 USB Driver InstallShield Wizard
To Next Page
Loading...
