44 MPA2C3 Installation Guide
Warning: MPA2C3 reader terminals are using shielded or foiled CAT5E, 6 or 7 S/FTP or F/UTP
cable with RJ45 connector. Be aware that this is NOT an Internet/Ethernet protocol
and so should not be mixed or connected to standard Ethernet Network devices as
switches or routers.
MPA2C3 2-door system reader configurations
In a 2-door system the left 2 RJ45 reader terminals are designated to Door 1 and
the readers can be connected as READER1 IN and READER1 OUT reader. The right
2 RJ45 reader terminals are designated to Door 2 and the readers can be con-
nected as READER2 IN and READER2 OUT reader
Figure 3-12 Location of the reader ports
To Next Page
Loading...
Need help?
General
