130 MPA2C3 Installation Guide
1. Connect the Ethernet cable as shown below to power the system via PoE+. Or
follow step 2 and step 3 to power the system via power supply.
1. Connecting the Ethernet Cable for PoE+
When the system is powered ON via PoE+ supply, ensure the Metal Enclosure is well connected
to Earth Ground, please see the picture below.
Warning: Make sure the PoE switch or PoE injector is compliant with UL294.
Warning: Do not apply power at this time. Ensure the PoE switch is not powered.
1. Connect prepared low voltage power supply cable (red, black, green/yellow) to
the PSU terminals (V+, V-). Ensure to secure the power cable by the cable
clamp.
Figure 4-4 Connecting the Power Supply Cable
To Next Page
Loading...
