Honeywell MPA2C3 - Page 151

MPA2C3 Installation Guide 145
Reader Support Reader 1-Wieg.A, 1-Wieg.B/
OSDP1,
Reader 2-Wieg.A, 2-Wieg.B/
OSDP2
4 WIEGAND readers: 2 doors/ IN AND
OUT readers per door
4 OSDP readers: 2 doors/ IN AND OUT
readers per door*
Output Voltage Range at RJ45 reader interfaces
when 12V internally powered
Reader 1 - Wieg.A / OSDP1,
Reader 1 - Wieg.B / OSDP1
10VDC ~ 14VDC
Maximum current output at RJ45 reader
interfaces
when 12V internally powered
500mA combined for both Wiegand readers
500mA for all OSDP readers*
Output Voltage Range at RJ45 reader interfaces
when 12V internally powered
Reader 2 - Wieg.A / OSDP2,
Reader 2 - Wieg.B / OSDP2
10VDC ~ 14VDC
Maximum current output at RJ45 reader
interfaces
when 12V internally powered
500mA combined for both Wiegand readers
500mA for all OSDP readers*
Voltage Range at RJ45 reader interfaces
when external voltage is applied at
Door 1: V - Ext.V Readers @ push in terminal
block
Reader 1 - Wieg.A / OSDP1,
Reader 1 - Wieg.B / OSDP1
14VDC ~ 24 VDC
Max output current at RJ45 reader interfaces
when external voltage is applied at
Door 1: V - Ext.V Readers @ push in terminal
block
1000mA combined for both Wiegand
readers
1000mA for all OSDP readers*
Voltage Range at RJ45 reader interfaces
when external voltage is applied at
Door 2: V - Ext.V Readers @ push in terminal
block
Reader 2 - Wieg.A / OSDP2,
Reader 2 - Wieg.B / OSDP2
14VDC ~ 24 VDC
Max output current at RJ45 reader interfaces
when external voltage is applied at
Door 2: V - Ext.V Readers @ push in terminal
block
1000mA combined for both Wiegand
readers
1000mA for all OSDP readers*
Outputs
Output Contact type OUT 1-2, AUX1-2 Selectable per jumper OUT 1-2, AUX1-2:
NO (Normally Open) or NC (Normally
Closed)
Aux Outputs 5-8 NO (Normally Open)
Relay contact max switching voltage and current
(dry contact)
OUT 1-2, AUX1-2 @ RJ45 500mA @ 30VDC,
500mA @ 22VAC
OUT 1-2, AUX1-2 @ push in
terminal block**,
Aux Outputs 5-8
3A @ 30VDC,
1A @ 22VAC
Max output Voltage at Door1/AUX1 output
when OUT1, AUX1 jumper onboard "12V” is
used (wet contact)
OUT 1 @ RJ45 or
OUT 1 @ push in terminal
block**,
AUX 1 @ RJ45 or
AUX 1 @ push in terminal
block**
10VDC ~ 14VDC