www.honeywell.com/security
92 | Performance Series IR 1080p IP PTZ Camera User Guide
Video Motion Detection
Figure 7-1 Motion Detection - Video Detection Configuration Interface
Table 7-1 Motion Detection Configurations
Parameter Function
Enable Check to enable motion detection.
Working Period
Configure the arm/disarm schedule. Click Setup to open the Working
Period page. See Configuring the Working Period on page 93 for more
information.
Anti Dither
The system logs and records only one event during the anti-dither
period. Choose an anti-dither period from 0 to 100 seconds.
Area
Configure the motion detection region, its sensitivity, and area. The
default settings covers the entire area. See Configuring the Motion
Detection Area on page 94 for more information.
Manual Control
Excluded
Select the Manual Control Excluded check box to disable manual PTZ
control while the Motion Event is active.
Record When Record is enabled, motion detection will trigger a recording.
Record Delay
The system can delay stopping a recording for a specified time after the
alarm has ended. Choose a delay period from 10 to 300 seconds.
Send Email
When this function is enabled, the system sends an email alert to you
when an alarm occurs. The email settings must be configured for this
feature to be used (see SMTP (Email) on page 59).
PTZ
Select the PTZ check box to program the camera to perform a PTZ
action, from Preset, Tour, or Pattern when the motion event is active.
Select the action from the drop-down list and then the number of the
Preset, Tour, or Pattern to perform from the second drop-down list.
Snapshot
Check to enable the system to save motion detection snapshot files (still
images) while the motion detection event is activated. See Path on page
65 for information about configuring where snapshots are saved.
To Next Page
Loading...
