HP Compaq nc6000 - Notebook PC Hardware Guide

3–14 Hardware Guide
Battery Packs
Discharging the Battery Pack
Before you begin a full discharge, disable Hibernation. To disable
Hibernation:
1. Open the Power Options window:
❏ In Windows 2000, select Start > Settings > Control
Panel > Performance and Maintenance > Power
Options > Hibernate tab.
❏ In Windows XP, select Start > Control Panel >
Performance and Maintenance > Power Options >
Hibernate tab.
2. Clear the Enable Hibernation check box
.
The notebook must remain on while the battery pack is being
discharged. The battery pack can discharge whether or not you
are using the notebook, but will discharge faster while the
notebook is in use.
■ If you plan to leave the notebook unattended during the
discharge, save your work before beginning the discharge
procedure.
■ If you use the notebook occasionally during the discharge
procedure and have set energy-saving timeouts, expect the
following performance from your system during the
discharge process:
❏ The monitor will not turn off automatically.
❏ Hard drive speed will not decrease automatically while
the notebook is idle.
❏ System-initiated Standby will not occur.
333644-001.book Page 14 Thursday, July 10, 2003 2:56 PM

HP Compaq nc6000 - Notebook PC Specifications

General

Processor	Intel Pentium M
Chipset	Intel 855PM
Storage	30 GB to 60 GB HDD
Hard Drive Interface	ATA-100
Battery	6-cell Lithium-Ion
Operating System	Windows XP Professional
RAM	256 MB, upgradable to 2 GB
Graphics	ATI Mobility Radeon 9600
Display	14.1-inch
Display Resolution	1024 x 768 or 1400 x 1050
Optical Drive	DVD-ROM, CD-RW/DVD Combo, or DVD±RW
Networking	10/100/1000 Ethernet
Ports	2 x USB 2.0, VGA, parallel, serial, headphone, microphone