HP Compaq nc6000 - Notebook PC Hardware Guide

Drives
Hardware Guide 4–5
Replacing the Primary Hard Drive
The hard drive that is in the hard drive bay is the primary hard
drive. Remove it only after the notebook is properly shut down.
Ä
CAUTION: To prevent system lockup and loss of information:
■ Shut down the notebook before removing the hard drive from the
hard drive bay. Do not remove the hard drive while the notebook is
on, in Standby, or in Hibernation.
■ If you are not sure whether the notebook is in Hibernation, turn the
notebook on by pressing the power button. Then shut down the
notebook through the operating system.
To remove the primary hard drive:
1. Save your work.
2. Shut down the notebook and close the display.
3. Turn the notebook bottom side up.
4. Remove the hard drive security screw 1.
5. Remove the hard drive retaining screw 2.
333644-001.book Page 5 Thursday, July 10, 2003 2:56 PM

HP Compaq nc6000 - Notebook PC Specifications

General

Processor	Intel Pentium M
Chipset	Intel 855PM
Storage	30 GB to 60 GB HDD
Hard Drive Interface	ATA-100
Battery	6-cell Lithium-Ion
Operating System	Windows XP Professional
RAM	256 MB, upgradable to 2 GB
Graphics	ATI Mobility Radeon 9600
Display	14.1-inch
Display Resolution	1024 x 768 or 1400 x 1050
Optical Drive	DVD-ROM, CD-RW/DVD Combo, or DVD±RW
Networking	10/100/1000 Ethernet
Ports	2 x USB 2.0, VGA, parallel, serial, headphone, microphone