HP Compaq nc6000 - Notebook PC Hardware Guide

7–4 Hardware Guide
External Devices
Enabling USB Legacy Support
You must enable USB legacy support to:
■ Use a USB keyboard, mouse, or hub connected to a
USB connector on the notebook during startup or in
a non-Windows application or utility.
■ Boot from an optional external MultiBay.
To enable USB legacy support:
1. Turn on or restart the notebook.
2. Press
f10 while the F10 = ROM Based Setup message is
displayed in the lower left corner of the screen.
❏ To change the language, press f2.
❏ For navigation instructions, press f1.
3. Select Advanced menu > Device Options.
4. Select Enable USB legacy support.
5. To save your preference and exit Computer Setup, select
File > Save Changes and Exit, then follow the instructions
on the screen.
333644-001.book Page 4 Thursday, July 10, 2003 2:56 PM

HP Compaq nc6000 - Notebook PC Specifications

General

Processor	Intel Pentium M
Chipset	Intel 855PM
Storage	30 GB to 60 GB HDD
Hard Drive Interface	ATA-100
Battery	6-cell Lithium-Ion
Operating System	Windows XP Professional
RAM	256 MB, upgradable to 2 GB
Graphics	ATI Mobility Radeon 9600
Display	14.1-inch
Display Resolution	1024 x 768 or 1400 x 1050
Optical Drive	DVD-ROM, CD-RW/DVD Combo, or DVD±RW
Networking	10/100/1000 Ethernet
Ports	2 x USB 2.0, VGA, parallel, serial, headphone, microphone