Drives
Hardware Guide 4–15
Removing an Optical Disc (No Power)
If power is unavailable:
1. Insert the end of a paper clip 1 into the release access in the
front bezel of the drive.
2. Press gently on the paper clip until the media tray is released,
then pull out the tray 2 until it is fully extended.
3. Remove the disc 3 from the tray by gently pushing down on
the spindle while lifting the outer edges of the disc. Handle
the disc by the edges, not the flat surfaces. If the media tray is
not fully extended, tilt the disc as you remove it. To protect
the disc, place it in a protective case.
4. Close the media tray.
333644-001.book Page 15 Thursday, July 10, 2003 2:56 PM
To Next Page
Loading...
