• To enable ports 24 through 31, you must purchase and install one upgrade license.
• To enable ports 32 through 40, you must purchase and install a second upgrade license.
See Installing and activating Port Upgrade licenses, page 25.
8/80 SAN Switch features
• Provides the EZSwitch Setup Wizard for easy setup and basic configuration.
• Integrates 1, 2, 4, and 8 Gb/s autosensing Fibre Channel switch and router ports.
• Includes a system motherboard that features a Freescale MPC8548 RISC CPU running at 1.3 GHz
with integrated peripherals that provides high performance with low power consumption.
• Ships FICON and FICON Cascading ready. FICON CUP is available, but requires an optional
license.
• Provides two hot-swappable, redundant power supply FRUs.
• Provides three hot-swappable fan FRUs in an N+1 configuration to provide hardware-redundant
cooling.
• Provides universal ports that self-configure as E_Ports, F_Ports, M_Ports, or FL_Ports. EX_Ports are
activated on a per-port basis with the optional HP B-series 48-80 Port SAN Switch Integrated
Routing LTU.
This license provides native FCR on a per-port basis, rather than limiting routing ports to those on
a dedicated routing blade or switch. Just like traditional FCR, Integrated Routing uses EX_Ports to
import and export devices between fabrics, enabling selective device sharing while maintaining
remote fabric isolation.
• Integrates a USB port that provides storage for firmware updates, output of the supportsave
command, and storage for configuration uploads and downloads.
Port side of the 8/80 SAN Switch
The port side of the 8/80 SAN Switch includes the system status LED, console port, Ethernet port and
LEDs, USB port, and FC ports with corresponding port status LEDs. Figure 4 shows the port side of
the 8/80 SAN Switch.
HP StorageWorks 8-Gb SAN Switches16
To Next Page
Loading...
