Figure 25 Encryption configuration
.
Configuring the FCoE Converged Network Switch
For more information on configuring the CEE portion of the FCoE Converged Network Switch, see
the Brocade Converged Enhanced Ethernet Administrator's Guide.
Configuring the 1606 Extension SAN Switch
The following sections provide information on configuring the 1606 Extension SAN Switch.
FCIP and Fibre Channel routing services configuration
Initially, the FC ports on the 1606 Extension SAN Switch are set to persistently disabled. If you want
to enable the FC ports as standard E_Ports or F_Ports, use the portcfgpersistentenable
command.
If you are using the FC ports as EX_Ports, you must configure the Fibre Channel Routing Services
feature before enabling the ports. The GbE ports can be used only after you have configured FCIP
and enabled the VE_Ports.
For instructions on configuring the Fibre Channel Router ports and GbE ports on the 1606 Extension
SAN Switch, see the Fabric OS Administrator's Guide.
Managing the 8-Gb SAN Switches56
To Next Page
Loading...
