4. Status LED1. 8/80 SAN Switch
5. Handle2. Fan assembly unit
6. Nonport side3. Captive screw
Figure 37 Inserting the fan assembly in the 8/80 SAN Switch
.
Replacing an 8/80 SAN Switch or Encryption SAN Switch
power supply
CAUTION:
If a power supply fails, leave the power supply in the switch until it can be replaced. Maintain both
power supplies in operational condition to provide redundancy.
Replacing a power supply takes approximately two minutes. You will need:
• 8/80 SAN Switch or Encryption SAN Switch
• New power supply
Managing the 8-Gb SAN Switches80
To Next Page
Loading...
