EasyManua.ls Logo

HP 1606 - Page 22

HP 1606
122 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
• Fabrics connected through FCIP merge if the ports are configured as VE_Ports, and do not
merge if one end of the connection is configured as a VEx_Port. If VE_Ports are used in a Fibre
Channel Routing Services backbone fabric configuration, then the backbone fabric merges
but the EX_Ports attached to edge fabrics do not merge. For more information, see the Fabric
OS Administrator’s Guide.
• FCIP Trunking with load balancing and network-based failure recovery
• Adaptive Rate Limiting
• Configurable minimum and maximum committed bandwidth per FCIP tunnel
• Minimum rate is guaranteed rate
• FC Frame Compression before FCIP Encapsulation
• FCR
• SOTCP with reorder resistance
• FastWrite over FCIP (not over FC)
• Open Systems Tape Pipelining over FCIP
• FCIP QoS
• TCP Performance Graphing in Web Tools
• FICON and FICON Cascading ready.
• FICON CUP (requires an optional license).
• FICON Accelerator for IBM TotalStorage z/OS Global Mirror (aka, XRC) and FICON Tape (requires
an optional license).
The 1606 Extension SAN Switch has the following hardware features:
• Up to 16 Fibre Channel SFP ports supporting Fibre Channel Switching or Fibre Channel Routing
Services, with link speeds of 1-, 2-, 4-, or 8-Gb/s
• Up to 6 1-GbE ports supporting the FCIP and Fibre Channel Routing Services features, with
transmit link speeds of up to 1-Gb/s on each port
Two ports (ge0 and ge1) can be configured for use with either copper or optical cables
• Rack–mountable 1U chassis
• Two PowerPC 440EPx processors running at 667 MHz
• One GoldenEye2 switch ASIC for 1, 2, 4, or 8 Gb/s FC switching
• One Cavium CN5740 running with 8 MIPS cores at 750 MHz for data path processing
• One Blaster FPGA for FC compression, offloads such as chksum generation/checks
• One 10/100/1000 Base-T Ethernet port for the management interface
• One RJ-45 terminal port
• One USB port for storing firmware updates, supportSave command output, and configuration
uploads and downloads
• Two redundant, hot-swappable combined power supply/fan assembly FRUs
• Five internal temperature sensors
HP StorageWorks 8-Gb SAN Switches22

Table of Contents