DescriptionItem
10 #10-32 x 1/2-inch Phillips panhead screws with captive star lock washers
8 #10 alignment washers
8 #10 adapter washers
Two 1/4-20 hex nuts with captive star lock washers
Two 1/4-inch flat washers
CAUTION:
For proper airflow, the SFP+ media side of the SAN Switch must face the rear of the rack. This allows
air to enter the front of the rack and exit from the rear.
To install the device in a rack:
1. Verify that the required parts and hardware are available. (See Table 5.)
2. Choose a mounting location for the device in the rack.
8-Gb SAN Switch Hardware Reference Guide 37
To Next Page
Loading...
