To Next Page

To Previous Page

3-57

Multiple Instance Spanning-Tree Operation

Displaying MSTP Statistics and Configuration

Displaying Per-Instance MSTP Configurations. These commands dis-

plays the per-instance port configuration and current state, along with

instance identifiers and regional root data.

Figure 3-24. Example of the Configuration Listing for a Specific Instance

Syntax: show spanning-tree config instance < ist | 1..16 >

The upper part of this output shows the instance data for the

specified instance. The lower part of the output lists the

spanning-tree port settings for the specified instance.

Syntax: show spanning-tree < port-list > config instance < ist | 1..16 >

This command shows the same data as the above command,

but lists the spanning-tree port parameter settings for only the

specified port(s) and/or trunk(s). You can list data for a series

of ports and port trunks by specifying the first and last port

or trunk of any consecutive series of ports and trunks. For

example, to display data for port A20-A24 and trk1, use this

command:

show spanning-tree a20-a24,trk1 config instance 1

HP Switch(config)# show spanning-tree config instance 11

MST Instance Configuration Information

Instance ID : 11

Switch Priority : 32768

Mapped VLANs : 111,300

Port Type | Cost Priority

----- --------- + --------- --------

1 10/100TX | Auto 128

2 10/100TX | Auto 128

3 10/100TX | Auto 128

4 10/100TX | Auto 128

Instance-Specific Data

Port Settings for the

specified instance.

Other manuals for HP 3500 Series

Questions and Answers:

Need help?

Do you have a question about the HP 3500 Series and is the answer not in the manual?

General