To Next Page

To Previous Page

8-5

Classifier-Based Software Configuration

Traffic Classes

■ If a default class is configured in the policy, the actions specified in the

default-class command are performed on packets that do not match the

criteria in preceding classes in the policy (see Step 3 in “Creating a Service

Policy” on page 8-25).

The following match criteria are supported in match/ignore statements for

inbound IPv4/IPv6 traffic:

■ IP source address (IPv4 and IPv6)

■ IP destination address (IPv4 and IPv6)

■ Layer 2 802.1Q VLAN ID

■ Layer 3 IP protocol

■ Layer 3 IP precedence bits

■ Layer 3 DSCP bits

■ Layer 4 TCP/UDP application port (including TCP flags)

■ VLAN ID

Traffic Class Configuration Procedure

To configure a traffic class to be used in one or more policies, follow these

steps:

1. Enter the class command from the global configuration context.

Context: Global configuration

Syntax: [no] class < ipv4 | ipv6 > <classname >

Defines a traffic class and specifies whether a policy is to be

applied to IPv4 or IPv6 packets, where < classname > is a

text string (64 characters maximum).

After you enter the class command, you enter the class

configuration context to specify match criteria. A traffic

class contains a series of match and ignore commands, which

specify the criteria used to classify packets.

The no form of the command removes the existing class.

Other manuals for HP 3500 Series

Questions and Answers:

Need help?

Do you have a question about the HP 3500 Series and is the answer not in the manual?

General