5-18
Quality of Service: Managing Bandwidth More Effectively
Globally-Configured QoS
Viewing a Global QoS Configuration
To display the existing switch-wide configurations for a global QoS classifier,
use one of the following show qos commands.
Syntax: show qos < global-classifier >
tcp-udp-port-priority
Displays the current TCP/UDP port priority configura-
tion. Refer to figure 5-7 on page 5-29.
device-priority
Displays the current device (IP address) priority con-
figuration. Refer to figure 5-9 on page 5-34.
type-of-service
Displays the current type-of-service priority configu-
ration. The display output differs according to the
option used:
■ IP Precedence: Refer to figure 5-14 on page 5-43.
■ Diffserve: Refer to figure 5-16 on page 5-47.
protocol-priority
Displays the current protocol priority configuration.
vlan-priority
Displays the current VLAN priority configuration.
Refer to figure 5-23 on page 5-57.
port-priority
Displays the current source-port priority configura-
tion. Refer to figure 5-28 on page 5-63.
To Next Page
Loading...
