To Next Page

To Previous Page

1-43

Static Virtual LANs (VLANs)

Configuring VLANs

Note You cannot use these commands with dynamic VLANs. Attempting to do so

results in the message “VLAN already exists.” and no change occurs.

WebAgent: Viewing and Configuring VLAN Parameters

In the WebAgent you can do the following:

■ Add VLANs

■ Rename VLANs

■ Remove VLANs

■ Configure VLAN tagging mode per-port

■ Configure GVRP mode

■ Select a new Primary VLAN

■ Enable/disable QinQ

■ Set Max VLANS

To configure other static VLAN port parameters, you will need to use either

the CLI or the menu interface (available by Telnet from the WebAgent).

1. Click on the VLAN folder.

2. Click on

VLAN Mgmt.

3. Click on the appropriate button for the desired task.

For web-based Help on how to use the WebAgent screen, click on the

[?] button

in the upper right corner of the WebAgent screen.

Other manuals for HP 3500 Series

Questions and Answers:

Need help?

Do you have a question about the HP 3500 Series and is the answer not in the manual?

General