To Next Page

To Previous Page

1-67

Static Virtual LANs (VLANs)

Migrating Layer 3 VLANs Using VLAN MAC Configuration

■ Immediately after you configure a VLAN MAC address or remove a

configured MAC address, a gratuitous ARP message is broadcast on the

connected segment to announce the change of the IP-to-MAC address

binding to all connected IP-based equipment.

■ A configured VLAN MAC address supports proxy ARP and gracious ARP.

■ A new MIB variable, ifRcvAddressTable, is introduced to support VLAN

MAC configuration.

■ You cannot configure a VLAN MAC address using the WebAgent or menu

interface. You must use the CLI.

■ VRRP is not supported on a VLAN interface with a user-configured MAC

address.

Example

The following example shows how to configure a MAC address on VLAN 101.

HP Switch# configure terminal

HP Switch(config)# vlan 101

HP Switch(vlan-101)# ip-recv-mac-address 0060b0-e9a200

interval 100

Verifying a VLAN MAC Address Configuration

To verify the configuration of Layer 3 MAC addresses on the VLAN interfaces

of a switch, enter the show ip-recv-mac-address command.

Figure 1-42. Example of Displaying a VLAN MAC Address

HP Switch# show ip-recv-mac-address

VLAN L3-Mac-Address Table

VLAN L3-Mac-Address Timeout

------------- ------------------------ -----------

DEFAULT_VLAN 001635-024467 60

VLAN2 001635-437529 100

Other manuals for HP 3500 Series

Questions and Answers:

Need help?

Do you have a question about the HP 3500 Series and is the answer not in the manual?

General