To Next Page

To Previous Page

5-25

Quality of Service: Managing Bandwidth More Effectively

Globally-Configured QoS

1. Identify the TCP or UDP port-number classifier you want to use for

assigning a DSCP policy.

2. Determine the DSCP policy for packets carrying the selected TCP or UDP

port number or range of port numbers.

a. Determine the DSCP you want to assign to the selected packets. (This

codepoint will be used to overwrite (re-mark) the DSCP carried in

packets received from upstream devices.)

b. Determine the 802.1p priority you want to assign to the DSCP.

3. If necessary, use the qos dscp-map < codepoint > priority < 0 - 7 > command

to configure the DSCP policy (codepoint and associated 802.1p priority)

that you want to use to mark matching packets.

Prerequisite A DSCP codepoint must have a preconfigured 802.1p priority (0 - 7) before

you can use the codepoint to mark matching packets. If a codepoint you want

to use shows No-override in the Priority column of the DSCP Policy table (show

Other manuals for HP 3500 Series

Questions and Answers:

Need help?

Do you have a question about the HP 3500 Series and is the answer not in the manual?

General