To Next Page

To Previous Page

6-16

Stack Management for the 3500, 3500yl, 6200yl and 6600 Switches

Configuring Stack Management

Figure 6-9. Example of the Stack Management Screen

2. Press

[A] (for Add) to add a Candidate. You will then see this screen listing

the available Candidates:

Figure 6-10. Example of Candidate List in Stack Management Screen

3. Either accept the displayed switch number or enter another available

number. (The range is 0 - 15, with 0 reserved for the Commander.)

4. Use the downarrow key to move the cursor to the MAC Address field,

then type the MAC address of the desired Candidate from the Candidate

list in the lower part of the screen.

5. Do one of the following:

For status descriptions, see the table on page 6-44.

The Commander automatically selects an

available switch number (SN). You have the

option of assigning any other available number.

Candidate List

Other manuals for HP 3500 Series

Questions and Answers:

Need help?

Do you have a question about the HP 3500 Series and is the answer not in the manual?

General