To Next Page

To Previous Page

7-24

QinQ (Provider Bridging)

Displaying QinQ Config and Status

Displaying the Configuration for a Particular VLAN. This command

uses the VID to identify and display the data for a specific VLAN. Once QinQ

is enabled in mixed vlan mode, an additional field showing the VLAN Type is

added to the display output.

For example:

Figure 7-11. Example of “Show VLAN” for a Specific VLAN (QinQ Enabled)

Syntax: show vlans < vlan-id >

(Changes to parameters when QinQ is enabled:)

VLAN ID: Field name changes from 802.1Q VLAN ID to VLAN

ID only.

Type: In a QinQ enabled environment, the VLAN type can be

either a regular customer VLAN CVLAN, or it can be a tunnel

VLAN in the provider network SVLAN.

HP Switch(config)# show vlan 10

Status and Counters - VLAN Information - Ports - VLAN 10

VLAN ID : 10

Name : Vlan-10

Type : SVLAN

Status : Port-based

Voice : No

Jumbo : No

Port Information Mode Unknown VLAN Status

---------------- --------- ------------- ------

1 Untagged Disable Down

2 Untagged Disable Down

3 Untagged Disable Down

4 Untagged Disable Down

5 Untagged Disable Down

When QinQ is enabled,

the VLAN Type field is

displayed.

Other manuals for HP 3500 Series

Questions and Answers:

Need help?

Do you have a question about the HP 3500 Series and is the answer not in the manual?

General