To Next Page

To Previous Page

8-7

Classifier-Based Software Configuration

Traffic Classes

When entering a match/ignore command in an IPv4

or IPv6 class, type ? to display a list of valid ip-

protocol entries.

• In an IPv4 class, you can enter any of the

following IPv4 protocol match criteria:

ahesp gre icmp* igmp*

ipip-in-ip ipv6-in-ip ospf pim

sctptcp* udp* vrrp

* For IPv4 ICMP, IGMP, TCP, and UDP packets, you

can enter additional match criteria; see:

“Optional ICMP Match Criteria” on page 8-14

“Optional IGMP Match Criteria” on page 8-17

“Optional TCP and UDP Match Criteria” on page

8-18

To specify an IPv4 protocol as match criteria, you

can also enter its protocol number. Valid values are

from 0 to 255.

For example, 8 means Exterior Gateway Protocol;

121 means Simple Message Protocol. For a list of IPv4

protocol numbers and corresponding protocol

names, refer to the IANA “Protocol Number Assign-

ment Services” at www.iana.com.

• In an IPv6 class, you can enter any of the

following IPv6 protocol match criteria:

ahesp icmp* ipv6

sctptcp* udp*

* For IPv6 ICMP, TCP, and UDP packets, you can

enter additional match criteria; see:

“Optional ICMP Match Criteria” on page 8-14

“Optional TCP and UDP Match Criteria” on page

8-18

Other manuals for HP 3500 Series

Questions and Answers:

Need help?

Do you have a question about the HP 3500 Series and is the answer not in the manual?

General