HP 54501A - Complete

COMPIete
COMPIete
command/query
The
:ACQUIRE:COMPLETE
command
specifies
the
completion
criteria
for
an
acquisition.
The
parameter
determines
what
percentage
of
the
time
buckets
need
to be
"full"
before
an
acquisition
is
considered
complete.
If
you
are
in
the
NORMAL mode
the
instrument
only
needs
one
data
bit
per
time bucket
for
that
time
bucket
to
be
considered full.
In
order
for
the
time bucket
to
be
considered
full in
the AVERAGE
or
ENVELOPE
modes
a
specified
number
of data
points
(COUNT)
must
be
acquired.
The
range
for
the
COMPLETE
command
is
0
to
100
and
indicates the
percentage
of
time
buckets
that
must
be
"full"
before
the
acquisition
is
considered
complete.
If
the
complete
value
is
set
to
100%,
all
time
buckets
must
contain data for
the
acquisition
to
be
considered
complete.
If
the
complete
value
is
set to
0
then
one
acquisition
cycle will
take
place.
The
COMPLETE
query returns
the
completion
criteria for
the
currently
selected
mode.
Command
Syntax:
:ACQuire:COMPIete
<comp>
Where:
Example:
Query
Syntax:
Returned
Format:
Example:
<comp> ::=
Oto 100
percent
OUTPUT
707;":ACQUIRE:COMPLETE
85"
:ACOuire:COMPIete?
[:ACOuire:COMPIete]
<compxNL>
Where:
<comp> ::=
Oto
100
(integer-
NR1
format)
DIM
Cmp$[50]
OUTPUT
707;":ACQUIRE:COMPLETE?"
ENTER
707;Cmp$
PRINT
Cmp$
Acquire Subsystem
8-4
HP 54501A
Programming