HP 54501A - Slope

SLOPe
SLOPe
command/query
The
:TRIGGER:SLOPE
command
specifies
the
slope
of the
edge
for the
trigger.
The SLOPE
command
is
valid
in the
Edge
Trigger
Mode,
State
Trigger
Mode,
and
Delay
Trigger
Mode
when
EDGE
or
STATE
is
selected as
the
qualifier.
The
SLOPE
query returns
the
current
slope
for
the
currently
selected
trigger
mode.
Command Syntax:
:TRlGger:SLOPe {NEGative
I
POSitive}
Example:
OUTPUT
707;":TRIGGER:SLOPE
POSITIVE"
Query
Syntax: :TRlGger:SLOPe?
Returned Format:
[:TRlGger:SLOPe] {POSitive
I
NEGative}
<NL>
Example: DIM
Ts$[50]
OUTPUT 707;":TR1G:SLOP?"
ENTER
707;Ts$
PRINT
Ts$
Trigger Subsystem
16-32
HP
54501A
Programming