Using the Camera Features
User’s Guide 10–5
Revised: 12/15/04
5. Press the Shutter button on the left side of the HP iPAQ or
press the Shutter icon ( ) on the screen to snap a photo.
Tip: You can also take photos by pressing down on the middle of
the Navigation button. Use the mode that is convenient for you.
When you snap a photo, your HP iPAQ makes two audible
shutter sounds (if you have not muted the sounds). Do not move
the camera until you hear the second shutter sound. A clock runs
on the screen to indicate that the photo has been taken and your
HP iPAQ is processing the photo. It may take a few seconds to
process and store the photo, depending on its size, quality, and
complexity.
Immediately after capturing an image, a preview of the photo you
just took appears so that you can decide to either discard, send, or
keep the image.
■ To discard the photo, tap on the Trash button on the screen
while the preview image is being displayed.
■ To e-mail or send the photo, tap on the Send button on the
screen:
❏ Select the method to be used (HP Instant Share E-mail,
E-mail Attachment, Bluetooth, Infrared, or MMS) and
follow the instructions on the screen.
Note: Notice that the attached image appears at the bottom of the
e-mail message.
■ To save an image, tap OK or simply wait for the preview to
disappear from the screen and the camera application to
return to the digital viewfinder.
HP
Confidential
To Next Page
Loading...
Need help?
General
