HP 75000 SERIES C User Manual

-330,"Self-test failed; unexpected Frat.-N chip sweep interrupt"
Triggered by: *tst? command This is a hardware fault. Please report
error and returned value from "ST? command to service personnel.
-330,"Self-test failed; VCO 30 MHz minus unlocked"
Triggered by: "st? command VCO unlocked by 30 MHz and minus
bit. This is a hardware fault. Please report error and returned value
from *TST? command to service personnel.
-330,"Self-test failed; VCO 30 MHz plus unlocked"
Triggered by: *tst? command VCO unlocked by 30 MHz and plus
bit. This is a hardware fault. Please report error and returned value
from
*TST? command to service personnel.
-330,"SeKtest failed; VCO 60 MHz minus unlocked"
Triggered by: "tst? command VCO unlocked by 60 MHz and minus
bit. This is a hardware fault. Please report error and returned value
from
*TST? command to service personnel.
-330,"Self-test failed; VCO 60 MHz plus unlocked"
Triggered by: *tst? comma.nd VCO unlocked by 60 MHz and plus
bit. This
is a hardware fault. Please report error and returned value
from *TST? command to service personnel.
-330,"Self- test failed; Voltage calibration failed: level FLIP FLOP is
defect"
Triggered by: 'TST? command. This is a hardware fault. Please
'.I
report error and returned value from "TST? command to service
personnel.
-330,"Self-test failed; Voltage calibration failed: level never above low
signal peak"
Triggered by: "TST? command. This is a hardware fault. Please
report error and returned value from 'TST? command to service
personnel.
-330,"Self-test failed; Voltage calibration failed: level never above high
signal peak"
Triggered by: 'TST? command. This is a hardware fault. Please
report error and returned value from *TST? command to service
personnel.
-330,"Self- test failed; Voltage calibration Wed: level never below high
signal peak"
Triggered by: *TST? command. This is a hardware fault. Please
report error and returned value from
*TST? command to service
personnel.
-330,"Self-test failed; Voltage calibration failed: level never below low
signal peak"
Triggered by: *TST? command. This is a hardware fault. Please
report error and returned value from 'TST? command to service
-
personnel.
E-8 Error Messages
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

HP 75000 SERIES C Specifications

General

Brand	HP
Model	75000 SERIES C
Category	Inverter
Language	English