HP 75000 SERIES C User Manual

X-Drive
This output ramps from 0 V to 10 V during a sweep.
Pen lift
This output provides a pen lift signal for a plotter at the end of a
signal.
Sync-Out TTL
A TTL compatible square wave synchronized output signal, is
available at this connector. The signal is synchronized with the
output signal crossover point (zero volts or
DC offset voltage). The
connector functions for frequencies up to 60 MHz.
Output
Standard output impedance is 50R. High-voltage option (001) output
impedance is nominally
< 3Q at DC, and < 10R at 1 MHz.
Ref Out 10MHz
A 10 MHz signal from the HP E1440A reference circuits is available
here.
Ref In 1/1OMHz
This external frequency reference may be used to phase-lock the
internal 30 MHz oscillator.
AM (f 5V)
An Amplitude Modulation input reference can be connected here for
input to the synthesizer circuit. Range is
*5 volts in all modes, i.e.
sine, square, triangle, ramps.
PM (f 5V)
A Phase Modulation input reference can be connected here for input
to the synthesizer circuit. Range is
f 5 volts in all modes, i.e. sine,
square, triangle, ramps.
Front Panel
Indicators
Failed
This red lamp illuminates as soon as power is applied to the module.
The module then checks out it's connections to the VXIbus i.e. it
checks that it is able to communicate with the mainframe. When
that check is verified, the module extinguished the Failed lamp.
Note
Absence of the Failed lamp does not necessarily mean that the
module is suit able for use.
Getting Started 1-7
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

HP 75000 SERIES C Specifications

General

Brand	HP
Model	75000 SERIES C
Category	Inverter
Language	English