HP 9304m - Page 145

Installation and Getting Started Guide
5 - 14
USING THE CLI
Enter the following command at any CLI level:
Syntax: show trunk [ethernet <portnum> to <portnum>]
The following table describes the information displayed by the show trunk command.
Table 5.2: CLI Trunk Group Information
This Field... Displays...
Trunk The trunk group number. The software numbers the groups in the
display to make the display easy to use.
Type The type of trunk group, which can be one of the following:
• Server – The trunk group is connected to a server.
• Switch – The trunk group is connected to another Routing Switch.
Ports The ports in the trunk group.
Duplex The mode of the port, which can be one of the following:
• None – The link on the primary trunk port is down.
• Full – The primary port is running in full-duplex.
• Half – The primary port is running in half-duplex.
Note: This field and the following fields apply only to operational trunk
groups.
Speed The speed set for the port. The value can be one of the following:
• None – The link on the primary trunk port is down.
• 10 – The port speed is 10 Mbps.
• 100 – The port speed is 100 Mbps.
• IG – The port speed is 1000 Mbps.
Tag Indicates whether the ports have 802.1q VLAN tagging. The value
can be Yes or No.
Priority Indicates the Quality of Service (QoS) priority of the ports. The
priority can be a value from 0 – 7.
HP9300(config)# show trunk
Configured trunks:
Trunk Type Ports
1 Switch 1/1 1/2 1/3 1/4 2/1 2/2 2/3 2/4
Operational trunks:
Trunk Type Ports Duplex Speed Tag Priority
1 Switch 1/1 1/2 1/3 1/4 2/1 2/2 2/3 2/4 None None No level0